In this article we’re going to look at how to create your own dog mask. We’ll cover the basics and then go on to look at a number of the more advanced tips and tricks which you can use.

For those who have a dog that likes to bark, and particularly if your dog loves to play in the garden and other areas of the house, you will need to get them some special dog protection.

Paper Plate 3d Dog Mask DIY Materials: This is the first part of the set-up which will look a little scary at first, but it’s actually quite simple. All you’ve got to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can’t just cut a rectangular shape from the cardboard, so you will need to cut around the edge of the mask so that you get something that resembles a cone. The most important thing here is to be realistic with what kind of paper plate that you’re using.

Then you’ll need to wrap the cardboard around the edges of the paper plate, making certain there is a dog air mask good seal between the two pieces so that you can make certain that nothing will leak once you put the mask on. Make sure that the edges are cut so that the edges aren’t sharp, as this may damage the edges of the mask.

Glue it on! The next step involves using some paint. You should spray the paint over the cardboard, making certain it runs smoothly and evenly across the entire mask. You’ll want to start with one side of the mask , so you can work your way round it before moving onto the other side. The paint has to be slightly thicker than the cardboard, and it’s best that you leave about one-fifth of an inch of paint on the edges so that it runs across the cardboard.

Don’t fret too much about the paint getting stuck into your mask. It’s easy to eliminate it later, and it will leave you with a nice finished mask to show off to everyone! It’s also a good idea to wipe away any excess paint after you’re done, so that you don’t wind up with smudges or smears on your dog.

Then it is time to glue the mask onto your dog’s head. First you need to make sure that you get a secure fit between the mask and your dog’s head. As soon as you’ve made sure that it is secure, then you may start to glue the mask on the dog’s face. Take the piece of cardboard that is used for the base of the mask and then fold it over. Be certain it’s quite powerful and then use your hands to secure the cardboard down in place.

Keep your hands out of the way and use tape to hold it in place as you repeat the procedure on the cardboard folds till you have the mask snugged firmly onto the surface of your dog. Do not make the folds too large or else it might look messy. As soon as you’ve completed this, you can then take out the mask and then attach the cardboard ears. And attach the other area of the mask on the dog. Be sure the ears are flat and be sure that it’s not too short or long as this can cause some issues with the mask slipping off the dog’s face.

If you are using a dog mask because your dog protection, you will need to do some sanding to be sure that it’s safe on your dog. You can do this by sanding off any excess paper that may have been eliminated from your mask.

Lascia un commento